Study the Performance of water Jet Pump by Changing the Angle of Mixing Nozzle.

Authors

  • S. R. Pandhare  Department of Mechanical Engineering, Prof Ram Maghe Institute of Technology and Research Badnera, Amravti University, Amravti , Maharastra, India
  • A. K. Pitale  Department of Mechanical Engineering, Prof Ram Maghe Institute of Technology and Research Badnera, Amravti University, Amravti , Maharastra, India

Keywords:

Jet Pump, Mixing Nozzle Angle, Nozzle Diameter, Ejector

Abstract

The experiment was about to study of water jet pumps with different angle of mixing nozzle. Most experimental studies on water jet pumps mainly carried out to assess the maximum efficiency. But maximum efficiency occurs when the suction lift is relatively small for a given head loss through the pump, which implies, when the suction flow rate is maximum. However, suction lift is inversely proportional to flow rate. But in the field of application there are many cases (such as drainage, dredging, well-pumping and other systems) where suction lift is more important factor than any other for water jet pumps, which gives importance to the assessment of depending factor of suction lift of water jet pumps. Three different jet pumps of one nominal diameter each of three different angle of mixing nozzle were made to carry out this experiment. The results revealed that the angle of mixing nozzle was an important parameter to characterize the suction lift of the jet pumps or not, but nominal diameter had a negligible play role.

References

  1. A. Saker, H. Z. Hassan. "Study of the Different Factors That Influence Jet Pump Performance." Scientific Research (june 2013): 44-49.
  2. A.H.Hammoud. "Effect of Design and Operational Parameters on Jet Pump Performance." International Conference on Fluid Mechanics and Aerodynamics. (Augest 2008): 245-252.
  3. L. Grinis, N. Lubashevsky, Y. Ostrovski. "Influence of the Flow Rate Ratio in a Jet Pump on the." International Journal of Mechanical, Aerospace, Industrial, Mechatronic and Manufacturing Engineering (November 2015): 1172-1175.
  4. Md. Mizanur Rahman, Md. Assad-Uz-zaman and Mohammad Mashud. "Performance Evaluation of Water Jet Pump for Nozzle to Throat Area Ratios on Suction Lift." International Journal of Mechanical & Mechatronics Engineering. (June 2014): 45-47.
  5. Santhosh Kumar Gugulothu, Shalini Manchikatla. "Experimental and Performance Analysis of Single Nozzle Jet Pump with Various Mixing TUbe." International Journal of Recent advances in Mechanical Engineering (november 2014): 119-133.
  6. Tarek A. Meakhail, Ibrahim R.Teaima. "A Study of the Effect of Nozzle Spacing and Driving pressure on the water jet pump performance." International Journal of Engineering Science and Innovative Technology. (september 2013): 373-382.

International Journal of Scientific Research in Science and Technology

Downloads

Published

2017-04-30

Issue

Volume 3, Issue 3, March-April-2017

Section

Research Articles

License

Copyright (c) IJSRST

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
S. R. Pandhare, A. K. Pitale, " Study the Performance of water Jet Pump by Changing the Angle of Mixing Nozzle., International Journal of Scientific Research in Science and Technology(IJSRST), Online ISSN : 2395-602X, Print ISSN : 2395-6011, Volume 3, Issue 3, pp.538-540, March-April-2017.