Desingning Of Cuk And Sepic Converter As Power Factor Preregulator

Authors

  • Sayali Sawarkar  Department of Electrical engineering Vidarbha Institute of Technology, Nagpur, Maharashtra, India
  • Prof. Rashmi Singh  Department of Electrical engineering Vidarbha Institute of Technology, Nagpur, Maharashtra, India

Keywords:

Cuk, SEPIC, converter.

Abstract

As the matter of concern due to huge electricity demand some improved conversion system are used for the improvement of power generation in this paper. The SEPIC and Cuk convertors which are working as power factor pre - regulators (PFP) have many desirable in discontinuous mode (DCM). In this paper we are designing the operation of both convertors as DCM-PFP. The SEPIC and Cuk are used with the solar energy, wind energy and fuel cell energy conversion system for improved electricity production. The combination of the Cuk and SEPIC convertors eliminate the need of additional input filters to filter out the high frequency harmonics. These type of DC to DC convertors are used in the applications where the output voltage is considerably greater than the input voltage. The Cuk and SEPIC convertors have certain advantages over the other conventional convertors such as: both Cuk and SEPIC convertors works as a voltage follower (i.e. it does not need any current loop), its power factor is unity theoretically and the input current ripple is obtained at designing stage. The results are simulated, verified and presented using MATLAB Simulink software.

References

  1. A.Sudharshan, M.Yohan, R.V.R.S.K.Shrujan, Y. Gayathri,”A Hybrid Wind-Solar Energy System Using Cuk-Sepic Fused Converter”. A. Sudharshan et al Int. Journal of Engineering Research and Applications, ISSN : 2248-9622, Vol. 3, Issue 6, Nov-Dec 2013, pp.287-293
  2. P.Ponmani,Ms.S.DivyaPriya,”Hybrid Solar-wind Energy System With MPPT Using Cuk-sepic Fused Converter”,International Journal of Engineering Research & Technology (IJERT) ISSN: 2278-0181,Vol. 4 Issue 01,January-2015.
  3. R. W. Erickson, “Some Topologies of High Quality Rectifiers” in the Proc. of the First International Conference on Energy, Power, and Motion Control, May 1997.
  4. D. S. L. Simonetti, J. Sebasti´an, and J. Uceda, “The Discontinuous Conduction Mode Sepic and ´ Cuk Power Factor Preregulators: Analysis and Design” IEEE Trans. On Industrial Electronics, vol. 44, no. 5, 1997.
  5. J. Marques, H. Pinheiro, H. Grundling, J. Pinheiro “A Survey on Variable-Speed Wind Turbine System,” Proceedings of Brazilian Conference of Electronics of Power, vol. 1, pp. 732-738, 2003.
  6. S.Venkatanarayanan,M.R.M NANTHINI,”Design and implementation of SEPIC and boost converters for wind and fuel cell applications,”International journal of innovative research in science,engineering and technology.

International Journal of Scientific Research in Science and Technology

Downloads

Published

2020-03-21

Issue

Volume 5, Issue 7, March-April-2020

Section

Research Articles

License

Copyright (c) IJSRST

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
Sayali Sawarkar, Prof. Rashmi Singh "Desingning Of Cuk And Sepic Converter As Power Factor Preregulator" International Journal of Scientific Research in Science and Technology(IJSRST), Online ISSN : 2395-602X, Print ISSN : 2395-6011,Volume 5, Issue 7, pp.313-316, March-April-2020.