Comparison of High Contact Ratio And Low Contact Ratio Gears

Authors

  • Jongoni Srinivas  Faculty of Mechanical Engineering, Keshav Memorial Institute of Technology, Hyderabad, India
  • Aapuri Laxminarsimha Rao  Faculty of Mechanical Engineering, Keshav Memorial Institute of Technology, Hyderabad, India

Keywords:

HCR, LCR, ANSYS, FEA, CAD

Abstract

In this work, comparison of high contact ratio gears and low contact ratio gears has been done for the same load. We have considered the bending strength, shearing at contact region, normal stress and some contact parameters like contact pressure, penetration and contact stiffness to compare HCR gears and LCR gears. in the results we have found that HCR gears r deforming less when compared to the later type for the same load transmitted. Bending strength in HCR gear set less when compared to the later one because of the load distribution among the teeth.

References

International Journal of Scientific Research in Science and Technology

Downloads

Published

2017-12-31

Issue

Volume 3, Issue 8, November-December-2017

Section

Research Articles

License

Copyright (c) IJSRST

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
Jongoni Srinivas, Aapuri Laxminarsimha Rao "Comparison of High Contact Ratio And Low Contact Ratio Gears" International Journal of Scientific Research in Science and Technology(IJSRST), Online ISSN : 2395-602X, Print ISSN : 2395-6011,Volume 3, Issue 8, pp.657-669, November-December-2017.