Comparative Sliding Wear Studies Among Flame Hardening and Induction Hardening Processes on 316l Stainless Steel
Keywords:
Flame Hardening, Induction Hardening, Metallographic test, Wear Resistance.Abstract
This task examines on acceptance induction and flame hardening processes so as to enhance the wear conduct of the material. The hardness of the material is expanded up to 200% by this procedure. Induction hardening process were done to 3 unique examples - a 1 minute, 2 minutes, and 3 minutes and named as IH1, IH2, and IH3 separately. Flame hardening process were completed to 3 distinct examples – 5 minutes, 10 minutes and 15 minutes and named as FH1, FH2, and FH3. The examples are to be amplified by metallographic test, for example, scanning electron microscope. The untreated example is utilized to contrast and the treated example. The best example is picked which decides the life of material and enhances the better wear protection. The hardness of untreated material and treated material were analyzed.
References
- Lee, M. K., Kim, G. H., Kim, K. H., & Kim, W. W. (2006). Effects of the surface temperature and cooling rate on the residual stresses in a flame hardening of 12Cr steel. Journal of materials processing technology, 176(1), 140-145.
- Lee, M. K., Kim, G. H., Kim, K. H., & Kim, W. W. (2004). Control of surface hardnesses, hardening depths, and residual stresses of low carbon 12Cr steel by flame hardening. Surface and coatings technology, 184(2), 239-246.
- Chou, Y. K. (2002). Surface hardening of AISI 4340 steel by machining: a preliminary investigation. Journal of Materials Processing Technology, 124(1), 171-177.
- Bokota, A., & Iskierka, S. (1998). Numerical analysis of phase transformations and residual stresses in steel cone-shaped elements hardened by induction and flame methods. International journal of mechanical sciences, 40(6), 617-629.
- Bartolomeu, F., Buciumeanu, M., Pinto, E., Alves, N., Carvalho, O., Silva, F. S., & Miranda, G. (2017). 316L stainless steel mechanical and tribological behavior? a comparison between selective laser melting, hot pressing and conventional casting. Additive Manufacturing.
- Ceschini, L., Lanzoni, E., Sambogna, G., Bordiga, V., &Schild, T. (2005). Tribological behavior and corrosion resistance of Kolsterized AISI316L austenitic stainless steel: existing applications in the automotive industry. Journal of ASTM International, 3(2), 1-9.
- Vardavoulias, M., Jeandin, M., Velasco, F., &Torralba, J. M. (1996). Dry sliding wear mechanism for P/M austenitic stainless steels and their composites containing Al2O3 and Y2O3 particles. Tribology International, 29(6), 499-506.
- Lo, K. H., Shek, C. H., & Lai, J. K. L. (2009). Recent developments in stainless steels. Materials Science and Engineering: R: Reports, 65(4), 39-104.
Downloads
Published
Issue
Section
License
Copyright (c) IJSRST
This work is licensed under a Creative Commons Attribution 4.0 International License.