Experimental Study on Young's Modulus of F. R. C. with Bottom Ash

Authors

  • S Ganesh  Department of Civil Engineering, St. Mark Educational Institution, Anantapur, Andhra Pradesh, India
  • D Mohammed Rafi  Department of Civil Engineering, St. Mark Educational Institution, Anantapur, Andhra Pradesh, India
  • A B S Dadapeer  Department of Civil Engineering, St. Mark Educational Institution, Anantapur, Andhra Pradesh, India

Keywords:

Hybrid Fibre, YOUNG'S MODULUS, Reinforced Concrete, HFRC, Bottom ash

Abstract

Main objective of this paper is to determine the modulus of elasticity of fibre reinforced concrete with the addition of bottom ash .And also to determine the strength of concrete by using polyolefin and steel fibres. Based on this paper we can use this polyolefin in construction of pavements, light precast elements and tunnel lining etc. By the use of hybrid fibre reinforced concrete we can improve the residual values from small deformations. The experiment investigation has been carried out on (HFRC) (combination of hooked end polyolefin & steel fibre ) get volume of aggregate fibre 0.6%, 1.1% and 1.3% was readied Workability conditions like blending, compaction and curing conditions. To adding of uniformly dispersed fibres to cementious concrete will give fitness to the construction and improve its dynamic, static properties.

References

  1. Bayasi et al (1991) "a study of modulus elasticity of FRC.
  2. DDL chung"Effect of hybrid fibres on mechanical actions& property of concrete", IJERA, ISSN 2248-9622, 2013.
  3. DrV.Bindiganivile (2013) "a study on concrete using bottom ash, manufactured sand and hybrid steel and coir fibres".
  4. Ezuddin AS And BalaguruPN(1992) "Normal and high strengths fibre reinforced concrete under compression".
  5. FM Kilnic kale , gg dogon(1993) "study of young’s modulus of steel fibre reinforced concrete, IJEAT,ISSN 2249-8958, vol 3,issue 4,april 2014.
  6. Han zhao(1992) "Mechanical properties of concrete using bottom ash manufactured sand and metallic fibres",IJIET,ISSN 2319-1058.
  7. Hyun woo(2012) standard tests process for compressive strength of cylindrical concrete specimens., ASTM 39/C 39M-01.
  8. Ibrahim turkmin,(2004) "Compressive behaviors of steel fibre reinforced concrete" research report, concrete division,LNEC 1464-4177(2005)Portugal.
  9. Misba gul,Alsaha Bashir,Javed A Naqash(2014) "strength modeling of high strength cocncrete with hfr" ISSN 1546-9239.
  10. Naman et al (1991) "compressive behaviour of steel fibre reinforced concrete .
  11. Naman et al(1991) "steel fibre reinforced self compacting concrete" , IJET,ISSN 4936-4943,vol 2,2010. reinforcing index",ASCE MT-1943-5533,2012.
  12. SChandrasekhar,(2005) " a virtual studies on stress-strain behavior of standard grade HFRSCC under confined and unconfined states,IJAET,ISSN:2231-1963,july 2011.
  13. Sideny Diomond et al (1995) "analytical modeling on stress-strain behavior of hybrid fibre reinforced self compacting concrete".
  14. Swami B.L.P (2006) "Behavior of steel fibres reinforced concrete in compression" research report,university of Canterbury.ASTM39/C.
  15. Vikrant.s., "experimental investigation on hybrid fibre reinforced concrete.

International Journal of Scientific Research in Science and Technology

Downloads

Published

2018-10-30

Issue

Volume 4, Issue 10, September-October-2018

Section

Research Articles

License

Copyright (c) IJSRST

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
S Ganesh, D Mohammed Rafi, A B S Dadapeer, " Experimental Study on Young's Modulus of F. R. C. with Bottom Ash, International Journal of Scientific Research in Science and Technology(IJSRST), Online ISSN : 2395-602X, Print ISSN : 2395-6011, Volume 4, Issue 10, pp.239-244, September-October-2018.