Experimental Studies on Estimation of Damping: Cantilever Beam

Authors

  • K. Guru Brahmam  Department of Mechanical Engineering, Chaitanya Bharathi Institute of Technology, Hyderabad-75, Telangana State, India

DOI:

https://doi.org/10.32628/IJSRST2293129

Keywords:

F-D curve, MATLAB, Logarithmic

Abstract

Present study deals with the finding the damping ratio experimentally for different methods and diffentiate between methods, such as Logarithmic decrement. Circle fit Method, F-D curve, half power method, and Sine sweep method. The assumptions followed is linear system where its dynamic behavior can be described by a second order diffential equation in It is time invariant, It is under damped system. MATLAB coding developed for above methods. Damping ratio is formulated and discussed for different methods.

References

  1. Y. Kumr , F. Hashimoto and S. Maeda, “Material Damping Of Cantilever Beam”, Journal of Sound and Vibration, 80(1), pp. 1-10, 1982.
  2. Fuxing Yin, Yoshiaki Ohsawa, Akira Sato and Kohji Kawahara, “Characterization Of The Strain-amplitude and Frquency Dependent Damping Capacity in the M2052 Alloy”, Material Transactions, 42(3), pp.385-388, 2001.
  3. Q. S. Li, K. Yang, N. Zhang, C.K.Wong and A.P. Jeary, “Field Measurements Of Amplitude Dependent Damping In a 79 Storey Tall Building and its effects on the structural dynamic responses”, Struct. Design Tall Build. 11, pp.129-153, 2002.
  4. Naoki Satake, Ken ichi Suda, Toshiharu Arakawa, Atsuki Sasaki, and Yuki Tamura, “Damping Evaluation Using Full Scale Data Of Buildings In Japan”, Journal of Structural Engineering, 197(4), pp.470-477, 2003.
  5. Y. Kume, F. Hashimoto, and S. Maeda, Material damping of cantilever beams. Journal of Sound and Vibration 80(1) (1982) 1-10.
  6. Fuxing Yin, Yoshiaki Ohsawa, Akira Sato and Kohji Kawahara, Characterization of the strain- amplitude and frequency dependent damping capacity in the M2052 Alloy. Materials Transactions 42(3) (2001) 385-388.
  7. Q. S .Li, K. Yang, N. Zhang, C. K. Wong and A. P. Jeary, Field measurements of amplitude-dependent damping in 79-storey tall building and its effects on the structural dynamics response. The structural design of tall buildings. 11, (2002) 129-153.
  8. Naoki Satake, Ken ichiSuda, Toshiharu Arakawa, Atsuki Sasaki, and Yuki Tamura, Damping Evaluation Using Full Scale Data Of Buildings In Japan, Journal of Structural Engineering, 197(4) ( 2003) 470-477.
  9. Neal Granick and Jesse E. Stern. Material damping of aluminum by a resonant-dwell technique. NASA technical Note TN D-2893. (1965) .
  10. R. F. Gibson and R. Plunkett. A Forced- Vibration Technique for Measurement of Material damping. Experimental Mechanics. Aug (1977) 297-302.

International Journal of Scientific Research in Science and Technology

Downloads

Published

2022-06-30

Issue

Volume 9, Issue 3, May-June-2022

Section

Research Articles

License

Copyright (c) IJSRST

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
K. Guru Brahmam "Experimental Studies on Estimation of Damping: Cantilever Beam" International Journal of Scientific Research in Science and Technology(IJSRST), Online ISSN : 2395-602X, Print ISSN : 2395-6011,Volume 9, Issue 3, pp.653-659, May-June-2022. Available at doi : https://doi.org/10.32628/IJSRST2293129